GB12 GB13
Disassembly
Before Use
-Disassembly and Assembly of the parts-
Remove the juice /
smoothie attachment or
frozen cone.
●
Squeezing screw comes out with it.
See page GB20 for how to install the gasket,
rubber plug and rubber brushes.
●
The juicer may not work properly if they
are not assembled correctly.
Squeezing screw
Top view
Outer bottom view
Push it in until
no gap.
●
Rubber brushes are located on side of the
rotating brush.
●
Rubber plug is located outer bottom.
●
Gasket is located in the juicing bowl.
Juice cone or
Smoothie cone
Rotating brush
Remove
the juicing
bowl from
the motor
housing.
Disassembly / Assembly of attachments
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
Separate the parts.
1
2
3
1
●
The following steps show how to disassemble / assemble attachments, using the juice attachment as an
example.
Assembly
●②
●①
Align the “
” mark on the motor housing and the
“
” on the juicing bowl.
Align the “
” mark on the motor housing and the
“
” mark on the juice / smoothie attachment.
1
Insert the squeezing screw into the centre.
2
Rotate the squeezing screw and push it into the
hole until it stops.
●
The lid cannot be closed if the squeezing screw is
not pushed down sufficiently.
●
Be careful not to get your finger clamped in the
gap between the squeezing screw and the juice
cone / smoothie cone.
Set the juicing bowl on the motor
housing.
Attach the rotating brush and juice cone / smoothie cone
or frozen cone, then set it on the motor housing.
Mount the squeezing screw.
2
3
4
Top view
Frozen cone
Frozen cone
Frozen cone
Comments to this Manuals