Model KX-A272Operating InstructionsDECT RepeaterPlease read before use and save.QUQX00130YA_01_A 20/1/04 6:40 pm Page 1
10 | Operating InstructionsDe-RegistrationIn order to perform de-registration, the repeater must have already been registeredto a base unit or cell st
Operating Instructions | 11Verification ToneRepeater coverage can be checked by using the in-built verification tone. Thecoverage area of the repeate
12 | Operating InstructionsSite Survey Mode (PBX option only)This function can be used to measure the transmission quality, and identifyproblematic tr
Operating Instructions | 13Serial Repeater ID programming (PBX option only)This function is used to control up to 3 repeaters in a chain configurati
14 | Operating InstructionsSerial Repeater ID programming continued.• Ensure that the repeater is switched OFF. (both LED’s are OFF)• Power ON the rep
Operating Instructions | 15Before Requesting HelpProblem Possible Cause SolutionNo function No power Check AC cord is plugged in(LED not lit) Not tur
16 | Operating InstructionsTechnical InformationSpecificationsStandard: DECT=(Digital Enhanced CordlessTelecommunications)Number of channels: 2 Duplex
Operating Instructions | 17CONDITIONS OF GUARANTEEThis guarantee is in addition to and does not in any way affect any statutory or otherrights of con
18 | Operating InstructionsIndexAccessories ...4Aut
Operating Instructions | 19QUQX00130YA_01_A 20/1/04 6:41 pm Page 19
2| Operating InstructionsTable of ContentsOverview ...
Hereby, Panasonic Communications Company (U.K.) Limited declares that this (KX-A272E) is in compliance with the essential requirements and other relev
Operating Instructions | 3OverviewA repeater is used when you need to extend the range of your cordless DECTtelephone or PBX cell station, to include
4| Operating InstructionsEnvironment• Do not use this unit near water.• This unit should be kept away from heat sources such as radiators, cookers, et
Operating Instructions | 5Wall MountingThis unit can be mounted on a suitable wall or placed on a flat surface.• Insert screws into wall. Avoid pipes
6| Operating InstructionsPlacementTo get the best performance from the repeater:• Select a raised position (on wall etc), which is well within range
Operating Instructions | 7Automatic RegistrationAutomatic registration cannot be performed if the repeater is already registered toanother base unit
8| Operating InstructionsManual RegistrationThere must be at least one handset already registered to the base unit or cellstation to carry out manual
Operating Instructions | 9Manual Registration continued.• Press ‘off hook’ on the handset. Thegreen LED will go steady ON.• Enter a unique identifyin
Comments to this Manuals