Panasonic EY7549 Operations Instructions download pdf (Page 12)

-

12

-

3. Removing the bit

Pull the top collar of the Quick change

chuckforward, then pull the bit.

CAUTION:

lmpact mechanism creates

heat.Square drive and acces-

sory may become very hot

and may cause skinburns. To

prevent skin burns, use work

gloves and/or allow heated

parts to cool down before han-

dling.

4. Detaching Quick change chuck

Pull the bottom collar of the Quick

change chuck forward to detach it.

Attaching or Removing

Bat tery Pack

1. To connect the battery pack:

Line up the alignment marks and at-

tach the battery pack.

• Slide the battery pack until it locks

into position.

Alignment marks

2. To remove the battery pack:

Pull the button from the front to re-

lease the battery pack.

Button

IV. OPERATION

[Main Body]

Switch Operation

1. The speed increases with the

amount of depression of the trigger.

When begin ning work, depress the

trigger slightly to start the rotation

slowly.

2. A feedback electronic controller is

used to give a strong torque even in

low speed.

3. The brake operates when the trig-

ger is released and the motor stops

immediately.

NOTE:

When the brake operates, a braking

sound may be heard. This is normal.

CAUTION:

When operating the tool by pulling

the trigger, there may be a momen-

tary lag before rotation starts. This

does not signal a malfunction.

* This lag occurs as the tool’s circuitry

starts up when the trigger is pulled

for the first time after installing a

new battery pack or after the tool

has not been used for at least 1

minute (or at least 5 minutes when

the LED is on). Rotation will start

without any lag during second and

subsequent operations.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 139 140

Comments to this Manuals

No comments