Panasonic KX-PS8100 User Manual Page 272

  • Download
  • Add to my manuals
  • Print
  • Page
    / 305
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 271
Chapter 10
272
Options
For the List of options, refer to the
Setup Manual
.
Upgrade options
The following upgrade options and consumables are available for the
KX-PS8100 from your local Panasonic reseller:
Hard Disk Drive (KX-PDHD1) for storing print jobs, and additional fonts
(page 275)
32 MB (KX-PEMD2) or 64 MB (KX-PEMD3) SDRAM DIMMs (page 278)
Three DIMM slots are available on the printer controller board. Each slot
can support a 16 MB, 32 MB or 64 MB SDRAM DIMM.
NOTE:
A minimum of 48 MB of SDRAM is required for duplicating.
Ethernet (KX-PNBC5) or Token Ring (KX-PNBC6) card (page 281)
You must remove the printer controller board from the back of the
KX-PS8100 printer in order to install or replace the hard disk, add or replace
memory, or install a Token Ring or Ethernet card.
IMPORTANT:
To prevent static electricity damage to any of the following components,
touch a grounded metal surface, such as the printer’s bare metal frame
prior to touching the component.
The interface connectors; SCSI, parallel, and optional network
ADF interface connector
Electrical components, connectors inside the printer, any components
on the optional board (hard disk drive, SDRAM DIMMs, Ethernet
network card, or Token Ring network card)
The connector pins on the optional 2nd cassette feeder for the printer
Page view 271
1 2 ... 267 268 269 270 271 272 273 274 275 276 277 ... 304 305

Comments to this Manuals

No comments