Panasonic BMED500 Operations Instructions Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9
Setting board
q Door sensor
Detects the door opening or closing. When you open
the door with the power on or 10 seconds have passed
after your turning on the power and opening the door,
the buzzer will beep to notify the administration PC that
the door is open. When you open the door for setting or
maintenance, refer to p.16.
Note: During normal operation, door-opening for more
than 10 seconds will disable the control unit. To
reset the disabled status, use the administration
software.
w Setup indicator
Shows the setting data or which numeric key has been
pressed.
e Operation mode switch (DSW3)
These switches are used for setting the operation mode
of the control unit.
r Buzzer
Beeps when the door is open or trouble has occurred to
the control unit.
t Buzzer-level adjustment knob
You can adjust the buzzer volume with this knob.
y Numeric buttons (0 to 9, and #)
These buttons are pressed when you set the IP address
or confirm the setting data of the control unit.
u Reset button (RESET)
This button is reserved for service.
Note: Keep hands away from this button except for ser-
vice personnel.
i Setting switches 1 (DSW 1)
These switches are reserved for service.
Notes:
Do not change the positions of these switches.
Error may occur.
Keep hands away from these switches except for ser-
vice personnel.
In the factory default setting, 6 and 7 have been set to
ON and others to OFF.
o Setting switches 2 (DSW 2)
These buttons are used for setting electric lock type
when you use electric locks. (Refer to p.18.)
POWER ALARM S3 S2 S1
CN1
IC102
E102E101CN504CN503
CN201
CN101
1 2 3 4 5
6 7 8 9
RESET
0
#
MIN
DSW1
DSW2
+–
BZ1
VR1
MAX
R1
R7
R6
R4
R5
1
1
9
OFF FSK
2 3 4 5 6 7 8
1
1
9
OFF FSK
2 3 4 5 6 7 8
1
9
3
OFF FSK
2 3 4 5 6 7 8
q
w
i
o
e
r y
u
t
1
OFF
2 3 4 5 6 7 8
DSW1
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments