Panasonic SCHT1000 Operations Instructions download pdf (Page 37)

RQT7061

RADIO &

SOUND

This mode is useful if you have to place your

surround speakers near the front speakers due

to the layout of your room.

This mode makes it seem like the sound from

the surround speakers is coming from behind

you.

Press and hold [SHIFT]r[MULTI REAR] for

more than 5 seconds.

Each time you do this:

V. R . S O N

!)V.R .S O FF

This mode makes it seem like sound is coming

from multiple rear surround speakers virtually

when connected with surround speakers.

Press [SHIFT]r[MULTI REAR].

Each time you do this:

M.R.S ON

!)M.R.S OFF

Using this function makes you feel like you are

sitting in the ideal seating position (in the center of

the circle formed by the speakers), even if you

cannot due to the layout of your room.

1 Press

[SHIFT]r[S.POSITION].

2 While “SEAT POSITION” is displayed

Press [3, 4, 2, 1] to select a

position.

To cancel

Press [SHIFT]r[S.POSITION] again.

[Note]

While virtual rear surround is on, the seat position is changed in

three horizontal steps.

Press [S W.LEVEL].

Each time you press the button:

SUB W 1>SUB W 2>SUB W 3>SUB W 4 (factory preset)

^-------------------------------------------------------------}

Adjust the level of the speakers so they are the same apparent level

as the front speakers where you would normally be sitting and

listening. (L, R ➡ below, Balance)

Preparation

≥Dolby Digital and DTS: Turn off the other sound field systems.

≥Dolby Pro Logic II: Press [SHIFT]i[ÎPRO LOGIC II].

1 Press [SHIFT]r[TEST] to output a test signal.

Lch: Front left

Cch: Center

Rch: Front right

RSch: Right surround

LSch: Left surround

2 Press [VOLUME r] or [s] to set the volume level normally

used for listening.

3 Press [3] (to increase) or [4] (to decrease).

L, R: (➡ below, Balance)

C, RS, LS: j6 dB to i6 dB

To stop the test signal, press [SHIFT]i[TEST] again.

∫ To adjust speaker level during play

1 Press [SHIFT]r[CH SELECT] to select the speaker.

LR>Cch>RSch>LSch>SWch

^---------------------------------------------------}

SW: Subwoofer

≥You can only adjust SW if there is output from the subwoofer

channel.

2 Press [3] (to increase) or [4] (to decrease).

L, R: (➡ below, Balance)

C, RS, LS: j6 dB to i6 dB

SW: j6 dB to i6 dB

You can adjust the balance of the front speakers.

1 Press [SHIFT]r[CH SELECT] to select “L R”.

2 Press [2, 1] to adjust the “L”, “R” balance.

Virtual Rear Surround

Multi Rear Surround

Seat position

Virtual speakers

V.REAR

Virtual speakers

M.V. REAR

Adjusting the bass

Speaker level adjustments

Balance

7061en.book 37 ページ２００３年７月１日　火曜日　午前１１時４４分

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

Comments to this Manuals

No comments

Panasonic SCHT1000 Operations Instructions Page 37

Comments to this Manuals