Panasonic KXTG1613FX Operations Instructions download pdf (Page 29)

Useful Information

Error messages

Troubleshooting

If you still have difficulties after following the instructions in this section, disconnect the base unit’s

AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the

handset.

General use

Display message Cause/solution

Memory Full L The phonebook memory is full. Erase unwanted entries (page

18).

Problem Cause/solution

The handset does not turn on even

after installing charged batteries.

L Place the handset on the base unit or charger to turn

on the handset.

The unit does not work. L Make sure the batteries are installed correctly (page

11).

L Fully charge the batteries (page 11).

L Check the connections (page 10).

L Unplug the base unit’s AC adaptor to reset the unit

and turn off the handset. Reconnect the adaptor, turn

on the handset and try again.

L Remove the batteries from the handset and install

again.

L The handset has not been registered to the base

unit. Register the handset (page 32).

The handset display is blank. L The handset is not turned on. Turn the power on

(page 14).

I cannot hear a dial tone. L Make sure that you are using the supplied telephone

line cord. Your old telephone line cord may have a

different wiring configuration.

L The base unit’s AC adaptor or telephone line cord is

not connected. Check the connections.

L Disconnect the base unit from the telephone line and

connect the line to a known working telephone. If the

working telephone operates properly, contact our

service personnel to have the unit repaired. If the

working telephone does not operate properly,

contact your service provider/telephone company.

TG161x_171xFX(e).book Page 29 Monday, February 9, 2015 4:06 PM

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36

No comments

Panasonic KXTG1613FX Operations Instructions Page 29