Panasonic MC-V7305 User Manual Page 13

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 12
j^ANGINNSlipEiEWliiS^
5. Reinsert the tab provid
ed on the end of Uie dust
cover into the grooves on
the dust compartment to
allow the cover to rotate
closed.
NOTE; The dust
cover must be com
pletely and correct
ly installed for
proper opera
tion.
6. Rotate the dust
cover up into the
closed posi
tion and press
into place.
NOTE: The dust bag
should not be
caught between the
lower edge of the dust
cover and the gasket as
indicated by the arrow In
the illustration.
«*ANfferSiWIW:WM
A secondary foam filter protects the motor
from dirt. When installing a new dust bag,
check this filter. Accumulated dirt in the
dust compartment will collect on the filter
and may restrict motor performance.
When the filter becomes dirty, pull It
from the bottom of the dust compart
ment and clean by rinsing with water.
When dry, slide the filter back into
place. Insert the secondary foam filter
with a ruler or something flat. It should
be fully inserted under the plastic rib
projections all the way to the rear.
ITie Electrostatic exhaust filter is located inside the dust
cover. The purpose of this fitter is to remove dust and dirt
from the recirculated air. When installing a new dust
bag, check this filter. When the filter becomes dirty,
remove it from the bottom of the dust cover by pulling
it straight up. Replace the filter. DO NOT CLEAN
WITH WATER*. Place the new filter back into the
dust cover with the six (6) slots in tite Tilter aligned
with the six (6) tabs on the dust cover, and mak
ing sure the rough side is facing up.
*Thls filter cannot be cleaned and should be replaced at least once each year if the clean
er Is used at least one hour each week.
Exhaust Filter
(Eiectrosbtic)
Dust Cover
- 13 -
Page view 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments