Panasonic SL1200GAEEG Operations Instructions download pdf (Page 24)

English

(24)

Before requesting service, make the below

checks. If you are in doubt about some of the

check points, or if the remedies indicated in the

chart do not solve the problem, contact your

dealer.

No power.

z

Is the AC mains lead plugged in?

Plug the mains lead in firmly. (



14)

There is power but no sound.

Sound is weak.

z

Are connections to the amplifier/receiver’s

PHONO terminals correct?

Connect the PHONO cables to the amplifier’s

PHONO terminals. (



14)

Left and right sounds are reversed.

z

Are the stereo connection cable connections

to the amplifier or receiver reversed?

Double check all connections. (



14)

z

Are connections of the head shell's lead wires

to the cartridge terminals correct?

Double check all connections. (



11)

Humming is heard during play.

z

Are there other appliances or their AC mains

lead near the stereo connection cable?

Separate the appliances and their AC mains

lead from this unit.

z

Is the earth lead connected?

Make sure the earth lead is correctly

connected. (



14)

The Strobe light or the blue

indicator blinks.

Perform the following operation when the

strobe light or the blue indicator blinks.

The symptom may be improved.



Turn [ON/OFF] to OFF.

k

Pull out the power plug, wait for three

seconds, and then insert the plug again.

l

Turn [ON/OFF] to ON and press

[START-STOP] to rotate the turntable.

z

If the strobe light or the blue indicator blinks

again, check which one is blinking and

contact our service representative.

Troubleshooting guide

Updating the firmware

To improve operation or add new functions,

the firmware for the unit is updated on an as

needed basis.

Before updating

z

From the support website, download the

firmware for version upgrade and create a

USB memory for version upgrade.

z

See the following website for how to create

a USB memory for version upgrade.

www.technics.com/support/firmware/

1

Turn [ON/OFF] to OFF and

remove the turntable.

(



13)

2

Connect the USB memory for

version upgrade to UPDATE

terminal of the

unit.

3

Turn [ON/OFF] to ON.

z

When update is

started, the update

lamps light up from

left to right.

4

Check that all of the four update

lamps are lit, and then turn

[ON/OFF] to OFF.

z

It takes approximately 120 seconds to

update the firmware.

5

Remove the USB memory.

Attention

z

Do not press [START-STOP] when the

turntable is removed.

z

Use a USB memory with FAT16 or FAT32

format.

z

Do not connect any USB device other than

the USB memory for version upgrade to the

UPDATE terminal of this unit.

z

No USB device can be charged from the

UPDATE terminal of this unit.

z

If after connecting the USB memory and

turning [ON/OFF] to ON, the update lamps

fail to light up within 15 seconds or they are

blinking, see the following website.

www.technics.com/support/firmware/

UPDATE

UPDATE

terminal

SERVICE

ONLY

Update lamps

24

1 2 ... 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments