Panasonic NVGS70 Operations Instructions download pdf (Page 11)

Before Use

-11-

≥The above operative ranges are for indoor use.

Outdoors or under strong light, the Movie

Camera may not operate properly even within

the above ranges.

≥Within a 1-metre range, you can also use the

Remote Controller on the LCD Monitor side of

the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used

simultaneously, they can be operated individually

by selecting different Remote Controller Modes.

≥If the Remote Controller Mode of the Movie

Camera and that of the Remote Controller do

not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [OTHER FUNCTIONS]

Sub-Menu to the desired Remote Controller

Mode. (

-17-)

Setup on the Remote Controller:

[VCR1]:

Press the [D] Button and [∫] Button

simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button

simultaneously. 2

≥When the battery in the Remote Controller is

replaced, the mode is automatically reset to

[VCR1] Mode.

Power Supply

ª Using the AC Adaptor

1 Connect the DC Input Lead to the Movie

Camera.

2 Connect the DC Input Lead to the AC

Adaptor.

INDEX INDEX

SELECT

STOP

KL

∫

STILL ADV

T

W

PAU SE

STILL ADV

61 5

;

ED

21

1

3 Connect the AC Mains Lead to the AC

Adaptor and the AC mains socket.

≥The AC Mains Lead’s outlet plug does not fit

entirely into the AC Adaptor socket. A gap will

remain as shown 1.

≥Before connecting or disconnecting the

power supply, set the [OFF/ON/MODE]

Switch on the Movie Camera to [OFF] and

make sure that [CAMERA/VCR/CARD PB]

Lamps are not lit.

ª Using the Battery

Before use, fully charge the Battery.

1 Attach the Battery to the AC Adaptor and

charge it.

≥Since the Battery will not be charged when

the DC Input Lead is connected to the AC

Adaptor, disconnect it from the AC Adaptor.

≥The [POWER] Lamp and [CHARGE] Lamp

lights up, and charging starts.

≥When the [CHARGE] Lamp goes off,

charging is completed.

2 Attach the charged Battery to the Movie

Camera.

Disconnecting the Power Source

Set the [OFF/ON/MODE] Switch (49) to [OFF]

and, while pressing the [PUSH BATT] Button

(52), slide the Battery or DC Input Lead upward to

disconnect it.

≥For other notes concerning this item, see

-58-.

PUSH

BATT

O

F

F

O

N

M

O

D

E

(52)

(49)

70B-ENG.book 11 ページ２００３年３月２７日　木曜日　午前１１時５３分

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments