Panasonic NVGS90 Operations Instructions download pdf (Page 13)

Before using

13

LSQT1290

ª To cancel Quick Start

1 Set [SETUP] >> [QUICK START] >> [OFF].

(

-16-)

≥The status indicator goes off and the power

turns off if the mode dial is set to OFF while the

unit is in quick start standby mode.

≥If the standby continues for approx. 30 minutes,

then the status indicator will go off and the

camera will be completely turned off.

≥In the following cases, quick start is cancelled

and the power turns off.

≥When the Mode dial is moved.

≥When the battery or AC adaptor is removed.

≥When the tape is removed while using the

battery in Tape Recording Mode.

≥When the movie camera is quick-started with

the white balance on automatic, it may take

some time until the white balance is adjusted if

the scene being recorded has a light source

different from the scene last recorded. (When

the colour night view function is used, however,

the white balance of the scene last recorded is

retained.)

≥If the power is turned on in quick start standby

mode, the zoom magnification becomes 2k and

the picture size may differ from what it was

before quick start standby mode.

≥If [POWER SAVE] (

-38-) is set to [5 MINUTES]

and the unit automatically goes into quick start

standby mode, close the LCD monitor and

retract the viewfinder and then open the LCD

monitor or extend the viewfinder again.

Inserting/removing a cassette

1 Fit the AC adaptor or the battery and turn on

the power.

2 Slide the [OPEN/EJECT] lever and open the

cassette cover.

≥When the cover is fully opened, the cassette

holder will come out.

3 After the cassette holder is opened, insert/

remove the cassette.

≥When inserting a cassette, orient it as shown

in the figure, and then securely insert it as far

as it goes.

≥When removing, pull it straight out.

4 Push the [PUSH] mark 1 in order to close

the cassette holder.

≥The cassette holder is housed.

5 Only after the cassette holder is completely

housed, close the cassette cover tightly.

≥When inserting a previously recorded cassette,

use the blank search function to find the position

where you want to continue recording. If you are

overwriting a previously recorded cassette, be

sure to find the position where you want to

continue recording.

≥When closing the cassette cover, do not get

anything, such as a cable, caught in the cover.

Caution:

Take care not to trap your fingers under the

cassette holder when closing it.

OPEN/

EJECT

1

PUSH

LSQT1290_ENG.book 13 ページ２００８年３月４日　火曜日　午後２時２０分

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 199 200

Comments to this Manuals

No comments