Panasonic PVGS9 Operations Instructions Page 15

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 14
15
Before Use
The Remote Control
Inserting the Button-type Battery
Before using the Remote Control, insert the supplied
button-type battery.
1 While pressing the Lock Button
1
, pull out
the Battery Holder. Then, remove the
button-type battery.
2 Insert the button-type battery with the (+)
marking facing upward.
3 Insert the Battery Holder into the Remote
Control.
When the button-type battery is exhausted, replace
it with a new CR2025 battery. (A battery is normally
expected to last about 1 year. However, it depends
on operation frequency.)
Make sure to match the poles correctly when
inserting the button-type battery.
WARNING
CAUTION
Replace Battery with Panasonic type
CR2025 only. Use of another battery may
present a risk of re or explosion.
Battery may explode if mistreated.
As with any small object, this type of Battery
can be swallowed by young children. Do not
allow children to handle this Battery.
Dispose of used battery promptly.
Do not recharge, disassemble or dispose of
in re.
Using the Remote Control
Distance from the Camcorder: Within
approximately 15 feet (5 meters)
Angle: Within approximately 15° in the vertical and
horizontal directions from the central axis
1 Direct the Remote Control at the Remote
Control Sensor
31
of the Camcorder and
press an appropriate button.
[VCR1]:
Press the [ ] Button and [ ] Button
simultaneously.
1
[VCR2]:
Press the [ ] Button and [ ] Button
simultaneously.
2
When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
The above operating ranges are for indoor use
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
If the Remote Control Mode of the Camcorder and
that of the Remote Control do not match, [CHECK
REMOTE MODE (REMOTE)] Indication is displayed.
Setup on the Camcorder:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Control Mode. (p. 21)
Setup on the Remote Control:
15°
15°
15°
15°
12
31
1
Page view 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 151 152

Comments to this Manuals

No comments