Panasonic PVGS9 Operations Instructions Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 152
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
16
Before Use
Using the Battery
Before use, fully charge the Battery.
Since the Battery will not be charged when the DC
Cable is connected to the AC Adaptor, disconnect
it from the AC Adaptor.
The [POWER] Lamp and [CHARGE] Lamp light
up, and charging starts.
When the [CHARGE] Lamp goes off, charging is
completed.
When the battery is completely discharged, the
[CHARGE] Lamp blinks at rst, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer than
usual.
We recommend using a Panasonic Battery.
We cannot guarantee the quality of this Camcorder
when batteries from other companies are used.
1 Attach the Battery to the AC Adaptor and
charge it.
For other notes concerning this item, see page 61.
Disconnecting the Power Source
Set the [OFF/ON] Switch
44
to [OFF], and while
sliding the [BATTERY RELEASE] Switch
48
,
remove the Battery downward or DC Cable.
When attaching or removing Battery, set the [OFF/ON]
Switch to [OFF] and make sure the [POWER] Lamp
is not lit.
Charging Time and Available
Recording Time
CGR-D08R
A
1 h
B
2 h 10 min. (1 h 45 min.)
CGR-D14
A
1 h 30 min.
B
3 h (2 h 25min.)
A
Charging Time
Maximum Continuous Recording Time
B
“1 h 30 min.” indicates 1 hour and 30 minutes.
Battery CGR-D08R (PV-GS9/PV-GS13) or
CGR-D14 (PV-GS15) is supplied.
The times shown in the table are approximate
times. The numbers indicate the recording time
when the View nder is used. The numbers in
parentheses indicate the recording time when the
LCD Monitor is used. In actual use, the available
recording time may be shorter.
The times shown in the table are for continuous
recording at a temperature of 68 °F (25 °C) and
humidity of 60 %. If the Battery is charged at a
higher or lower temperature, the charging time
may be longer.
The available recording time becomes shorter
if you use both of View nder and LCD Monitor
simultaneously when rotating the LCD Monitor
forward to record yourself or setting [EVF ON/
AUTO] to [ON].
44
48
2 Attach the charged Battery to the Camcorder.
Power Supply
Using the AC Adaptor
1 Connect the DC Cable to the Camcorder.
2 Connect the DC Cable to the AC Adaptor.
3 Connect the AC Cable to the AC Adaptor and
the AC Jack.
Before connecting or disconnecting the power
supply, set the [OFF/ON] Switch
44
on the
Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit. (p. 18)
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 151 152

Comments to this Manuals

No comments