Panasonic SDRH80 Operations Instructions download pdf (Page 14)

LSQT1469

The unit is in the standby condition when the AC adaptor is connected. The primary circuit is always

“live” as long as the AC adaptor is connected to an electrical outlet.

Important:

While the DC cable is connected to the AC adaptor, the battery will not charge.

1 Connect the AC cable to the AC

adaptor and the AC outlet.

2 Connect the DC cable to the AC

adaptor.

3 Connect the DC cable to this unit.

≥ Do not use the AC cable with any other

equipment as it is designed only for this unit.

Also, do not use the AC cable from other

equipment with this unit.

Battery capacity indication

≥ The display changes as the battery capacity reduces. ####

If there is less than 3 minutes remaining, then will become red. If the battery discharges,

then ( ) will flash.

≥ The remaining battery capacity is displayed when using the Panasonic battery that you can use for

this unit. It may take time to display the remaining battery capacity. The actual time can vary

depending on your actual use.

≥ The maximum amount of remaining battery capacity able to be indicated is 9 hours 59 minutes. If

the actual remaining time exceeds 9 hours 59 minutes, the indication will stay green and will not

change until the remaining time falls below 9 hours 59 minutes.

≥ When turning the mode dial to switch modes, the time indication will turn off momentarily in order to

recalculate the remaining battery capacity time.

≥ When using the AC adaptor or batteries made by other companies, the remaining battery capacity

will not be shown.

Connecting to the AC outlet







1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 109 110

No comments

Panasonic SDRH80 Operations Instructions Page 14