Panasonic CS-A9CKPG User Manual download pdf (Page 62)

1. The Electronic Controller, a Signal Receiver and an

Indicator (Fig. 3) can be seen by the below steps:

•

Remove the 2 caps and 2 screws at the bottom of the

Front Grille. (Fig. 1)

•

Remove the Front Grille by releasing the 2 hooks at the

top of the Front Grille. (Fig. 1)

•

Remove the Control Board Cover by releasing the 2

tabs at left, 1 tab on top and 1 tab at right side of the

Control Board Cover. (Fig. 2)

2. To remove the Electronic Controller:

•

Release the Particular Piece. (Fig. 3)

•

Release the hook that hold the Electronic Controller.

(Fig. 3)

•

Remove the Control Board by:-

−

Releasing CN-REC/DISP connectors. (Fig. 4)

−

Releasing CN-FM connectors. (Fig. 4)

−

Releasing CN-STM connector. (Fig. 4)

−

Removing the Earth Wire screw. (Fig. 4)

−

Releasing the Intake Air Sensor. (Fig. 4)

−

Releasing the Piping Sensor. (Fig. 4)

Fig. 1

Fig. 2

Fig. 3

Fig. 4

13 Servicing Information

Caution:

•

Pb free solder has a higher melting point than standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use

a high temperature soldering iron. In case of the soldering iron with temperature control, please set it to 700 ± 20°F (370 ± 10°C).

•

Pb free solder will tend to splash when heated too high (about 1100° F/600°C).

13.1. Indoor Electronic Controllers Removal Procedures

13.2. Indoor Fan Motor and Cross Flow Fan Removal Procedures

CS-A9CKPG CU-A9CKP6G / CS-A12CKPG CU-A12CKP6G

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 81 82

Comments to this Manuals

No comments

Panasonic CS-A9CKPG User Manual Page 62

Comments to this Manuals

Related products and manuals for Conditioners Panasonic CS-A9CKPG