Panasonic PT-AE8000U Operations Instructions download pdf (Page 18)

About your projector

18 -

ENGLISH

Preparation

Remote control

■

Top

■

Front

Adjust the zoom and focus.

Display the [MEMORY

LOAD] menu.

Display the input waveform.

Reset adjusted menu values

to the default settings.

Use for menu screen

operation.

Display the [3D SETTINGS]

menu.

Allocate frequently used operations

and use as a shortcut button.

Inserting and removing the remote control batteries

Open the cover.

Insert the batteries and

replace the cover (insert

from

side).

Display the menu screen.

Switch the input signals.

Cycle through the

[PICTURE MODE].

Display the [VIERA LINK]

menu.

Remote control signal transmitter

Send remote control signal.

Point at the remote control receiver part on the

projector when using.

Attention

Do not drop the remote control.

Avoid contact with liquids or moisture.

Do not attempt to disassemble or modify the remote control.

Note

Pressing buttons on the remote control when button lights is set to on illuminates the button lights.

Button lights dim if no actions are carried out after approximately 5 seconds, and then extinguish if no actions are carried

out after a further 5 seconds.

When pointed directly at the receiver on the front of the projector, the remote control can be used up to a distance of

approximately 7 m (23'). It may also be used at a vertical/horizontal angle of up to ±30 degrees.

The remote control may not operate correctly if there is an obstacle between it and the receiver on the projector.

Signals from the remote control can be reected off a screen when using the projector, but limitations to the range of

operability may occur due to reected light loss resulting from the properties of the screen.

The remote control may not be usable if the receiver is exposed to uorescent or other strong lights. As far as is possible,

keep the remote control away from light sources.

When viewing 3D images the remote control may not respond well in some cases. (



page 70)

● Follow the reverse

procedure to remove the

batteries.

About your projector

Display menus of external devices

when using VIERA Link.

Change the operation mode during

gamma adjustment.

Change the detection level of parallax

when the parallax adjustment monitor

is displayed (when [Mode3] is set).

With the <MAIN POWER> switch of the

projector turned <ON>, switch between

the standby mode and projection mode.

Display the [PICTURE] menu or

[ADVANCED MENU] menu.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 109 110

Comments to this Manuals

No comments

Panasonic PT-AE8000U Operations Instructions Page 18

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PT-AE8000U