Panasonic PT-AE8000U Operations Instructions download pdf (Page 80)

[OPTION] menu

80 -

ENGLISH

Settings

• [BLANK]

When [BLANK] is activated, output is 12 V. If the

setting is released, output is 0 V.

• [RS-232C COMMAND LINK]

Receives commands (



page 103) from external device

and outputs 12 V.

Input

[POWER ON/OFF] [BLANK]

• [POWER ON/OFF]

If the trigger input signal from the external device is

changed from 0 V to 12 V, the projector power will be

switched on. And if it is changed from 12 V to 0 V, the

power will be switched off.

• [BLANK]

If the trigger input signal from the external device is

changed from 0 V to 12 V, the screen will go blank. And

if it is changed from 12 V to 0 V, the [BLANK] setting

will be released.

3) Press the ▲▼◄► buttons to move the

cursor to [DELAY TIME]

4) Press the ◄► buttons to set the delay

time for the trigger output signal

The delay time can be set to 2, 4, 6, 8, 10, 20, and

30 seconds.

It is possible to delay the trigger output signal (12 V)

by the amount of time set. (Only available if trigger

output item is selected.)

E.g.) Select [SELECT 4:3 ASPECT] of the trigger output

function and set the delay time to 10 seconds.

Set the [ASPECT] in the [POSITION] menu to [4:3],

and 12V is output from the trigger port after 10

seconds.

Note

You should not use trigger terminal output as the power

source for other devices.

The projector will not accept trigger input while preparing

to project after the power has been switched on and

while preparing to shutdown after projection. Input trigger

signals after projection starts or after entering standby

mode.

12 V cannot be output from the trigger terminal when the

projector is in standby mode.

[SLEEP]

Set the time for the power to be automatically turned

off.

Switch settings Switch settings

[OFF] Inactive

[60MIN.] Turn power off after 60 minutes

[90MIN.] Turn power off after 90 minutes

[120MIN.] Turn power off after 120 minutes

[150MIN.] Turn power off after 150 minutes

[180MIN.] Turn power off after 180 minutes

[210MIN.] Turn power off after 210 minutes

[240MIN.] Turn power off after 240 minutes

Note

The projector automatically enters power off preparation

mode (the power indicator illuminates orange), and then

enters standby mode (the power indicator illuminates or

ashes in red). (



page 28)

3 minutes before turn-off, the number of minutes

remaining will be displayed in the lower right corner.

If [SLEEP] mode is set to [OFF] mode before the

specied time has elapsed the settings are erased.

[HIGH ALTITUDE MODE]

Set to [ON] when using at locations between 1 400 m

(4 593 ft) and 2 700 m (8 858 ft) above sea level.

Switch settings Switch settings

[OFF]

When using at an altitude of less

than 1 400 m (4 593 ft) above

sea level

[ON]

When using at high altitudes

(between 1 400 m (4 593 ft) and

2 700 m (8 858 ft) above sea

level)

Note

The fan rotation and operating noise increases if set to

[ON].

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 109 110

Comments to this Manuals

No comments

Panasonic PT-AE8000U Operations Instructions Page 80

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PT-AE8000U