Panasonic PTD3500U User Manual download pdf (Page 32)

How to use ADVANCED MENU

ADVANCED MENU

SELSCT RETRN

INPUT RESOLUTION

BLANKING

DIGITAL CINEMA REALITY

CLAMP POS.

SXGA

SXGA MODE

RASTER POSITION

ENTER

INPUT RESOLUTION

Input resolution adjustment achieves the best

image when the screen flickers or halo is observed

around the contour.

: These select the items listed below.

: These select the value.

“TOTAL DOTS”, “DISPLAY DOTS”, “TOTAL

LINES” and “DISPLAY LINES”

Each item automatically displays a value in response

to the type of the input signal. If vertical stripes

appear on the screen or the image is partly missing,

increase or decrease the displayed value while

observing the screen to achieve the optimal value.

DIGITAL CINEMA REALITY

(Only for input of S-Video/ Video/ YP

[480i,

576i] signals.)

ON: Set at ON when you need to faithfully

capture images shot at 24 frames per

second as in movies.

OFF: Set at OFF when unnatural images are

obtained in the ON status.

BLANKING

You can perform fine adjustments for blanking if

noise appears at the ends of the screen or the

image protrudes out of the screen during image

projection using a video deck and so on.

: Select the UPPER, LOWER, LEFT or

RIGHT adjustment.

: Adjust the blanking width.

• The abovementioned vertical stripes

will not appear on the screen when all

signals are input.

•

The picture may be distorted during the

adjusting operation, but this is not a fault.

• The input resolution can be adjusted

only when RGB signal input is applied

with RGB1 and RGB2 IN.

Note

CLAMP POS.

(For RGB/ YP

signals only)

Use the clamp position adjustment to achieve the

optimal value when dark areas of the image are

crushed or displayed in green.

Adjust with the buttons.

The value changes from 1 to 255.

The optimal value for the clamp position adjustment

• If dark areas are crushed:

The optimal value is the point where the dark

area is best improved.

• If the dark areas are displayed in green:

The optimal value is the point where the

green area becomes dark and clear.

RASTER POSITION

When the whole area where the input picture can

be displayed is not used, the picture can be moved

to any position inside the display area.

: These adjust the value in the horizontal

direction.

: These adjust the value in the vertical

direction.

SXGA MODE

This mode takes effect only when SXGA (RGB)

signals are input.

SXGA : Standard setting

SXGA+: Select this when the screen is cut off.

• The clamp position can be adjusted

only when the RGB signal input is

applied with RGB1 and RGB2 IN.

Note

For lower adjustment For upper adjustment

For right adjustmentFor left adjustment

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 71 72

Comments to this Manuals

No comments

Panasonic PTD3500U User Manual Page 32

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PTD3500U