Panasonic WV-SP302 Installation Guide download pdf (Page 27)

When using 12 V DC power supply*

q Loosen the screw of the power cord plug (accessory).

w Connect the cable of the 12 V DC power supply* to the

power cord plug.

Strip 3 mm to 7 mm {1/8 inches to 9/32 inches} from the

end of the wire, and twist the stripped part of the wire

sufficiently to avoid short circuit.

Specification of cable (wire): 16 AWG - 24 AWG,

Single core, twisted

 • Check whether the stripped part of the wire is not

exposed and is securely connected.

e Tighten the screw of the power cord plug.

r Connect the power cord plug to the 12 V DC power sup-

ply terminal on the rear of the camera.

* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC

CLASS 2 POWER SUPPLY.

Important:

 • Besuretousethepowercordplugprovidedwiththisproduct.

 • Besuretofullyinsertthepowercordplugintothe12VDCpowersupplyterminal.Otherwise,

it may damage the camera or cause malfunction.

 • Wheninstallingthecamera,makesurethatexcessiveforceisnotappliedtothepowercable.

 • Be suretousean ACadaptorcompliantwiththeSpecificationsregardingpowersourceand

power consumption (

☞ page.32).

When using PoE (IEEE802.3af compliant)

Connect a LAN cable (category 5 or better, straight, STP*) between a PoE device (such as a hub)

and the network connector of the camera.

* PAL models only.

Important:

 • Useall4pairs(8pins)oftheLANcable.

 • Themaximumcablelengthis100m{328feet}.

 • MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.

 • Whenconnectingboththe12VDCpowersupplyandthePoEdeviceforpowersupply,PoE

will be used for power supply.

 • WhendisconnectingtheLANcableonce,reconnectthecableafteraround2seconds.When

the cable is quickly connected, the power may not be supplied from the PoE device.

POWER

10BASE T/100BASE-TX

AUDIO OUT MIC/LINE IN

EXT I/O

MONITOR OUT

ACT LINK

12V = IN

GND 4 3 2 1

INITIAL

SET

SD CARD/ABF

ALARM IN 1/DAY/NIGHT IN

AUX OUT

ALARM OUT

To 12 V DC

power supply*

(This illustration represents

WV-SP306.)

(12 V DC)

(GND)

12 V DC power

cord plug

(accessory)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Comments to this Manuals

No comments

Panasonic WV-SP302 Installation Guide Page 27

Comments to this Manuals

Related products and manuals for Security cameras Panasonic WV-SP302