Panasonic WV-BP100 User Manual download pdf (Page 15)

2. Installation of Auto Iris Lens Connector

When you use-an auto iris lens other than listed on

pages 9,10 and 11, for example a video servo ALC lens,

install the lens connector (YFE4191J100) coming with

the camera as follows.

The following installation should be made by

qualified service personnel or system installers.

(1) Cut off the iris control cable at the edge of lens

connector and then cut off the outer cable cover as

shown in the diagram.

Iris Control Cable Cut Off Lens Connector

(3) Put the heat shrinkable tubes or equivalent tubes on

the inner cables of the iris control cable.

{4) Solder the inner cable of the iris control cable at

the pin-plug block according to the following pin

assignment and cover the heat shrinkable tubes or

equivalent tubes over the soldered area and heat

on the tubes to shrink them.

Pin 1 : Power source : +9V DC, 50 mA Max.

Pin 2 : Not used

Pin 3 : Video signal : 0.7Vp-p/40 kohms

Pin 4 : Shield, ground

(Set the Lens Selection Switch (5) to the VIDEO

Position)

Pin 2

(2) Cut off the inner cable covers of the iris control

cable as shown in the diagram.

1 /4" (Approximately B mm)

- 13 -

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

No comments

Panasonic WV-BP100 User Manual Page 15