Panasonic WV-BP100 User Manual download pdf (Page 16)

(5) Both the connector cover and connector should be

positioned to interlock.

Note:

Cut off the rib on the connector, when the iris

control cable is too thick and the connector

cover and connector can not be interlocked.

3. Mounting the Lens

When you use the lens other than listed on pages 9,

10,11 and 12, lens mount should be C-mount or special

C-mount (CS-mount r-32UN) and lens weight should

be less than 0.99 lbs. (450g). If not, both the lens and

camera should be secured.

The protrusion of the rear of the lens should be as shown

below.

C-mount : Less than 7/16“ (11.5 mm)

CS-mount : Less than 1/4* (72 mm)

Caution:

Always set the Flange-back adjusting ring to fully

clockwise (C-mount side) by loosing screws on the

ring before mounting the lens, otherwise the inner

glass and CCD image sensor could be damaged by

the lens.

(1) Mount the lens by turning it clockwise onto the lens

mount of the camera,

(2) Connect the lens cable to the Auto Iris Lens

Connector on the camera when an auto iris lens

is used.

(3) Set the Lens Selection Switch (5) to the proper

position as follows.

- 14 -

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Panasonic WV-BP100 User Manual Page 16