Panasonic ERGC71 User Manual download pdf (Page 15)

English

Lubrication

• Apply the oil to the clipper before and after each use.

• Make sure that the clipper is turned off.

Remove the blade.

Apply a drop of the oil to each

indicated point.

Attach the blade to the main

body, turn on the power and

allow to run for approximately

5 seconds.

Removing and mounting the blade

Removing the blade

Hold the clipper with the switch facing

upward and push the blade with your

thumb while catching the blade in your

other hand.

Mounting the blade

Fit the mounting hook (B) into the blade mounting (A) on the

clipper and then push in until you hear a click.





Troubleshooting

Perform the following actions.

If the problems still cannot be solved, contact the store where

you purchased the unit or a service centre authorized by

Panasonic for repair.

Problem Action

The blade has not been

cleaned properly.

When the clipper is very dirty,

remove the blade and wash with

water. (See page 14.)

Makes a loud sound.

Conﬁrm that the blade is properly

attached.

The clipper has become

blunt.

Replace the blade.

(See this page.)

Clean the blade and apply oil.

(See pages 14 and 15.)

Clipper stopped

functioning.

Operating time is short.

Charge the clipper.

Or use with the AC operation.

(See page 10.)

Charge the battery for

approximately 16 hours

continuously to rejuvenate it.

If few uses remain even after

charging, the battery has reached

the end of its life. (Fluid may be

leaking due to degradation at the

end of battery life.)

Contact an authorized service

centre for repair.

ER-GC71_51_EU.indb 15 2016/01/28 17:44:58

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 259 260

Comments to this Manuals

No comments

Panasonic ERGC71 User Manual Page 15

Comments to this Manuals

Related products and manuals for Hair trimmers & clippers Panasonic ERGC71