Panasonic KX-HGW600 User Manual download pdf (Page 95)

Operating Instructions

[For assistance, please call: 1-800-272-7033] 95

System

Features

Instructions for the data fields

Note

When Auto is displayed in the Current Status table, you cannot change the

settings because the KX-HGW600 has set up Network Camera automatically.

Entry Check Enabled or Disabled. When you check Enabled,the

entry works as specified. When you check Disabled,the

entry does not work but will work when you check Enabled

later.

Protocol Select the protocol(s) to send or receive data to/from the

WAN side. TCP, UDP, TCP&UDP, ICMP or PPTP are

available.

Forwarding Port No. Set the port number(s) to send or receive data to/from the

WAN side. Do not enter the space.

• When a single port is desired, set the port number.

• When a range of port is desired, enter the range using "-".

For example, to set the port numbers from 2000 to 3000,

enter as "2000-3000". The starting port number must be

lower in value than ending port number.

The port numbers from 60000 to 60016 are only available

for the KX-HGW600.

Forwarding IP

Address

Enter the private IP address of each device connected to the

KX-HGW600. A data from the Internet is forwarded to the IP

address entered in this data field. In this case, set the IP

address of the corresponding Network Camera to this value.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 151 152

No comments

Panasonic KX-HGW600 User Manual Page 95