Panasonic WJ-GXE100 Installation Guide download pdf (Page 21)

When using 12 V DC power supply*

q Loosen the screws of the power cord plug

(accessory).

w Connect the cable of the 12 V DC power

supply*tothepowercordplug.

Strip the end of the wire by 3 mm - 7 mm

{1/8 inches - 9/32 inches}, and twist the

stripped part of the wire sufficiently to avoid

short circuit.

Specification of cable (wire):

16 AWG - 24 AWG, Single core, twisted

 • Check whetherthe strippedpart ofthe wire

is not exposed and is securely connected.

e Tighten the screws of the power cord plug.

(Recommended tightening torque:

0.34 N·m {0.25 lbf·ft})

r Connect the power cord plug to the 12 V DC power

supply terminal on the unit.

t Tie the power cord and LAN cable together using

the cable tie (accessory). Tie the cables together so

that they cannot be easily pulled out from the unit by

leaving sufficient slack in the cables.

*FORULLISTEDMODEL(S),ONLYCONNECT12VDC

CLASS 2 POWER SUPPLY.

IMPORTANT:

 • Be sure to use the power cord plug provided with

this product.

 • Besuretofullyinsertthepowercordplug(accesso-

ry) into the 12 V DC power supply terminal.

Otherwise, it may damage the unit or cause malfunc-

tion.

 • Make connections so that excessive force is not

applied to the power cord or the LAN cable when

they are connected.

 • Be sure to use an AC adaptor compliant with the

Specifications regarding power source and power

consumption. (

☞

Page 28)

(12 V DC)

(GND)

Power cord plug

(accessory)

To 12 V DC power supply

Cable tie

(accessory)

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Comments to this Manuals

No comments

Panasonic WJ-GXE100 Installation Guide Page 21

Comments to this Manuals

Related products and manuals for Security cameras Panasonic WJ-GXE100