Panasonic WJ-GXE100 Installation Guide download pdf (Page 22)

When using PoE (IEEE802.3af compliant)

ConnectaLANcable(category5orbetter,straight,STP*)betweenaPoEdevice(suchasahub)

and the network connector of the unit.

*Emodelonly

IMPORTANT:

 • Useall4pairs(8pins)oftheLANcable.

 • Themaximumcablelengthis100m{328feet}.

 • MakesurethatthePoEdeviceinuseiscompliantwithIEEE802.3afstandard.

 • When connecting both the 12 V DC power supply and the PoE device for power supply,

12 V DC will be used for power supply. Depending on the PoE device used, the power supply

lamp may not light and the network connections may not be possible. In this case, disable the

PoE device setting, and refer to the operating instructions of the PoE device in use.

 • WhendisconnectingtheLANcableonce,reconnectthecableafteraround2seconds.When

the cable is quickly connected, the power may not be supplied from the PoE device.

 • MakeconnectionssothatexcessiveforceisnotappliedtotheLANcablewhenitisconnected.

 • ThecameraistobeconnectedonlytoPoEnetworkswithoutroutingoutsideplantwhenusing

PoE.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

No comments

Panasonic WJ-GXE100 Installation Guide Page 22