Panasonic CU-TE12DKE User Manual download pdf (Page 46)

11.3.1. SELECT THE BEST LOCATION

(Refer to “Select the best location”

section)

11.3.2. INSTALL THE OUTDOOR UNIT

•

• •

•

After selecting the best location, start installation according

to Indoor/Outdoor Unit Installation Diagram.

1. Fix the unit on concrete or rigid frame firmly and horizontally

by bolt nut. (ø10 mm).

2. When installing at roof, please consider strong wind and

earthquake. Please fasten the installation stand firmly with

bolt or nails.

11.3.3. CONNECTING THE PIPING

Connecting The Piping To Indoor Unit

Please make flare after inserting flare nut (locate at joint portion

of tube assembly) onto the copper pipe. (In case of using long

piping)

Connect the piping

•

• •

•

Align the center of piping and sufficiently tighten the flare

nut with fingers.

•

• •

•

Further tighten the flare nut with torque wrench in specified

torque as stated in the table.

MODEL Piping size (Torque)

Gas Liquid

TE9CK 3/8” (42 N.m) 1/4” (18 N.m)

TE12CK 1/2” (55 N.m) 1/4” (18 N.m)

Connecting The Piping To Outdoor Unit

Decide piping length and then cut by using pipe cutter. Remove

burrs from cut edge. Make flare after inserting the flare nut

(located at valve) onto the copper pipe.

Align center of piping to valves and then tighten with torque

wrench to the specified torque as stated in the table.

Cutting And Flaring The Piping

1. Please cut using pipe cutter and then remove the burrs.

2. Remove the burrs by using reamer. If burrs is not

removed, gas leakage may be caused.

Turn the piping end down to avoid the metal powder

entering the pipe.

3. Please make flare after inserting the flare nut onto the

copper pipes.

11.3. OUTDOOR UNIT

CS-TE9DKE CU-TE9DKE / CS-TE12DKE CU-TE12DKE

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 79 80

Comments to this Manuals

No comments

Panasonic CU-TE12DKE User Manual Page 46

Comments to this Manuals

Related products and manuals for Conditioners Panasonic CU-TE12DKE