Panasonic PT-TW240U Operations Instructions download pdf (Page 21)

Using Remote control

ENGLISH -

Preparation

Installing and Removing battery

Press the guide and pull 1 )

out the battery base.

CR2025

Install new battery into 2 )

the compartment.

CR2025

Remove the old

Lithium coin cell

battery and install

new one (CR2025).

Ensure that the side

with a “+” is facing

up.

Put the battery base 3 )

back.

CR2025

Attention

When discarding a lithium coin battery, be sure both sides (+/-) are covered with adhesive insulating tape, such as and the

cellophane tape, and discard it according to the instructions of the local government.

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each

projector individually using single remote control, if unique ID number is assigned to each projector.

After setting the remote control ID of the projector, set the same remote control ID to the remote control.

There are 7 different remote control IDs: [All], [ID1]~[ID6], the initial remote control ID is [All].

Setting the remote control ID

1) While holding down the <MENU> key, press the <IMAGE> key. The number of times you press the

<IMAGE> key corresponds to the desired remote control ID.

The number of times to press the <IMAGE> key is as follows:

ID1 = Once, ID2 = Twice, ID3 = 3 times, ID4 = 4 times, ID5 = 5 times, ID6 = 6 times.

2) The remote control ID is changed when the <MENU> button is released.

Resetting the remote control ID

The remote control ID is reset to [All] (default) by pressing the <MENU> key and <IMAGE> key at the

same time for 10 seconds or more.

Note

When operating the projector under [All] code, you can operate several projectors at the same time.

If the <IMAGE> button is pressed 7 times or more, the remote control ID cannot be changed (the operation is invalid).

For setting the remote control ID codes, see [Remote ID] in the [Setting] menu. (

page 43)

If the battery is not in use for a long period of time and is removed from the remote control, the remote control ID will be

reset.

Using Remote control

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 73 74

Comments to this Manuals

No comments

Panasonic PT-TW240U Operations Instructions Page 21

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PT-TW240U