Panasonic PT-TW240U Operations Instructions download pdf (Page 31)

Powering ON/OFF

ENGLISH -

Basic Operation

Powering On the Projector

Before switching on the projector, make sure all the other devices are correctly connected (

pages 27-28).

Connect the power plug to the power outlet.1 )

Enter Standby status when the <ON(G)/STANDBY(R)> indicator is lighting / blinking in red.

Press the <2 )

> button on the control panel or the remote control.

When the <ON(G)/STANDBY(R)> indicator lights up in green, the lamp is on.

Startup screen is displayed for about 10 seconds, then the image will be projected.

Note

If the power is disconnected due to the power breaker during projection at the last use,

the <ON(G)/STANDBY(R)>

indicator will light in green automatically at the next startup and the image will be projected.

Powering Off the Projector

Press the <1 )

> button on the control panel or the remote control.

The following message appears.

Message will disappear after about 30 seconds when there is no operation.

Press the <2 )

> button again.

The projection stops and the <ON(G)/STANDBY(R)> indicator on the projector ashes up in red. (Fan is

still spinning.)

Wait until the <ON(G)/STANDBY(R)> indicator lights / blinks in red (The fans stop 3 )

spinning).

The projector enters standby mode when the <ON(G)/STANDBY(R)> indicator lights / blinks in red.

Note

Do not turn on the power and project images immediately after turning the projector off. Turning on the power while the

lamp is still hot may shorten the lamp life.

Make sure that the projector is cool enough if you want to pack it for transportation and storage.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 73 74

No comments

Panasonic PT-TW240U Operations Instructions Page 31