Panasonic PT-TW240U Operations Instructions download pdf (Page 27)

Connections

ENGLISH -

Getting Started

Before connecting to the projector

Read carefully the instruction manual for the device to be connected.

Turn off the power switch of the devices before connecting cables.

If any connection cable is not supplied with the device, or if no optional cable is available for connection of the

device, prepare a necessary system connection cable to suit the device.

Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture.

In this case, a time base corrector (TBC) must be connected.

The projector accepts the following signals: VIDEO, analogue-RGB (with TTL sync. Level) and digital signal.

Some computer models are not compatible with the projector.

When using long cables to connect with each of equipment to the projector, there is a possibility that the image

will not be output correctly unless a compensator is used.

For details on what video signals the projector supports, see “List of compatible signals”. (

pages 68-69)

Attention

When connecting with a video deck, be sure to use the one with a built-in time base corrector (TBC) or use a TBC between

the projector and the video deck.

If nonstandard burst signals are connected, the image may be distorted. If this is the case, connect a TBC between the

projector and the video deck.

Note

Use an HDMI cable that conforms to HDMI standards such as an HDMI High Speed cable. If a cable that does not meet

HDMI standards is used, video may be interrupted or may not be displayed.

When connecting the 1080p signal using HDMI, use a cable compliant with 1080p signal.

This projector does not support the VIERA Link (HDMI).

Connecting example: Computers

Audio equipment

Control

Computer

Monitor

Computer

Connections

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

No comments

Panasonic PT-TW240U Operations Instructions Page 27