Panasonic PTAE2000E Operations Instructions download pdf (Page 41)

OPTION menu

ENGLISH - 41

Settings

When installing the projector, select the projection

method according to the projector position. Press I H

to cycle through the options. See “Projection method” on

page 15.

You can select the required duration of time and set the

off timer to turn off the power of the projector

automatically. 3 minutes before turn-off, the countdown

of minutes will be displayed in the lower right corner.

Press I H to cycle through the options. See “Switching

off the projector automatically” on page 25.

If you use the projector at high elevation, the ALTITUDE

setting need to be HIGH to set the fan speed high. Press

I H to select the required option.

LOW The fan speed is low.

HIGH The fan speed is high.

You can adjust the power of the lamp to save on

electricity, prolong the lamp life and reduce the noise.

You can check how long the lamp has been used.

INSTALLATION

FRONT/DESK

Setting on a desk/floor and

projecting from front

FRONT/CEILING

Mounting in the ceiling and

projecting from front

REAR/DESK

Setting on a desk/floor and

projecting from rear

REAR/CEILING

Mounting in the ceiling and

projecting from rear

SLEEP

ALTITUDE

NOTE:

• At 1 400 m (4 593 ft) above sea level, the setting must

be HIGH.

• The loudness of fan noise depends on the ALTITUDE

setting.

LAMP POWER

Options Function

NORMAL

When higher luminance is

required.

ECO-MODE

When lower luminance is

sufficient.

NOTE:

• When no input signal is detected, the function is

disabled.

LAMP RUNTIME

NOTE:

• LAMP RUNTIME is a relevant matter for lamp

replacement timing. See “Replacing the lamp unit” on

page 44.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 57 58

Comments to this Manuals

No comments

Panasonic PTAE2000E Operations Instructions Page 41

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PTAE2000E