Panasonic KX TGA420B User Manual download pdf (Page 10)

Installation

Battery Charge (To Use the Battery Power Mode)

The station unit can be used with the AC adaptor connected {AC power

mode). However, if you want to move the station unit with the AC adaptor

disconnected for your convenience, charge for about 8 hours before initial

use. Make sure the battery is installed properly and the AC adaptor is

connected (p. 8, 9).

Battery strength

You can check the battery strength on the display.

The battery strength is shown as in the chart below.

Display prompt

^hih;

i bhI

(flashing)

Battery strength

Fully charged

Medium

Low

Needs to be recharged.

• If you do not install the battery with the AC adaptor connected, “■[115 ” will flash

and “Install battery” will be displayed. However the unit will work with the

AC power.

Recharge

Connect the AC adaptor to recharge the battery

when:

— “Recharge” is displayed,

flashes on the display, or

— the station unit beeps intermittently while it is in use.

• If you DO NOT recharge the battery for more than 15 minutes, the display will

keep indicating “Recharge” and/or “ tZH ” will continue to flash.

• After the battery is fully charged, you can disconnect the AC adaptor and move

the unit to your convenient place.

• If you charge the discharged battery, it will be charged quickly. In that case the

area of the battery may feel warm. This is normal.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 75 76

No comments

Panasonic KX TGA420B User Manual Page 10