Panasonic MC-V7305 User Manual download pdf (Page 14)

WARN/NG

Electric Shock or Personal Infury Hazard.

When the lower plate Is removed for any reason, before reinstalling, be sure that all elec

trical wires are routed In a manner that prevents them from coming Into contact with the

lower plate, lower plate screws, or any moving parts. Be sure that the wires are not

pinch^ in any way when the lower plate Is reinstalled.

Before replacing any parts, disconnect the vac

uum cleaner from the electrical outlet.

TWO 4

Screws

Two Locking Tabs

Replacing some of the parts in this section involves

the removal and installation of the lower plate. Always

place paper under the nozzle anytime the lower plate

is removed to protect the floor surface.

Lower

Plate

To Remove Lower Plate.

Start by placing the handle in the upright position.

See the HANDLE ADJUSTMENTS section. Turn the

vacuum cleaner over, exposing the underside. Release the

lower plate by removing the two (2) screws and pressing inward on

the two (2) locking tabs that secure the lower plate, as shown in the illus

tration. Remove the lower plate and remove any residue that may exist in the belt area.

To Reinstall Lower Plate.

Hook the front end of lower plate into the slots on the front of the nozzle housing. Press the

lower plate into place until the locking tabs snap into place then replace the two (2) screws.

NOTE:

To ensure maximum cleaning efficiency, the belt should be checked regularly to make

sure it is in good condition. Check to see if the belt Is stretched, cracked, or if excessive slippage

has occurred. Replace If necessary.

1. Remove the lower plate using the procedure in the

REMOVING/INSTALLING THE LOWER PLATE sec

tion.

2. Grasp the bulb socket, wiggle the socket back and

forth while pulling it up out of the nozzle housing. To

remove the old bulb, push it in toward the bulb socket

while turning counterclockwise, then remove,

3. Install the new bulb by pushing it in toward the bulb

socket and turning it clockwise. Use any standard

bayonet base appliance bulb rated at 130 Volts AC/15

Watts.

NOTE:

Do not use a bulb rated over 130 Volts AC/

15 Watts. During extended use, heat from the bulb could overheat the surrounding plastic parts.

4. Reinsert the bulb socket into the nozzle housing by pushing it back down into the slot.

Replace the lower plate as outlined in the REMOVING/INSTALLING THE LOWER PLATE section.

- 14-

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Comments to this Manuals

No comments

Panasonic MC-V7305 User Manual Page 14

Comments to this Manuals

Related products and manuals for Vacuums Panasonic MC-V7305