Panasonic WJ-HD100 User Manual download pdf (Page 38)

● Resetting Alarm

The activated alarm is reset by any of the inputs below.

• The preset time has elapsed.

• The [■ STOP] button on the front panel is pressed.

• The alarm reset signal is supplied from the connected

device.

Resetting changes the status of the recorder as follows:

• The recorder stops alarm recording.

• The buzzer, if activated, stops beeping.

• The recorder outputs an alarm recovery signal from the

rear panel.

• The Alarm Out signal on the rear panel is reset.

■ Copy to CompactFlash Card

The pictures recorded on the hard disk can be copied to a

CompactFlash card for browsing on a personal computer.

The picture quality depends on the card capacity and the

quality in which the pictures were recorded.

The following card brand proved to be suitable in tests car-

ried out at Panasonic:

Manufacturer Capacity (in MB)

SanDisk 32, 48, 64, 96, 128, 160, 192

1. Insert a CompactFlash card.

1-1 Open the card lid.

1-2 Place a CompactFlash card into the slot.

The card must be formatted for Windows 95 or

Windows 98. Do not reverse the card when insert-

ing.

1-3 Make certain to push the lever to the right after

inserting the card.

2. Display the desired picture on the monitor.

Refer to Skip Playback and Step Playback on page 35

for search operations.

3. Press the JogDial to freeze the image just a few fields

prior to where you wish to start copying.

4. Press the LCD button downward to display [Copy To

Card].

Open the lid.

1-1

1-2

1-3

Push the lever to the

right after inserting

the card.

DISPLAY SELECT

STOP PLAY REC

PUSH– PAUSE

SET

ALARM SEARCH STEP REW/FF

PLAY MODE SELECT

SETU/ESC

LCD CONTRAST

Digital Disk Recorder WJ-HD

3, 6

DISPLAY SELECT

LCD CONTRAST

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 59 60

Comments to this Manuals

No comments

Panasonic WJ-HD100 User Manual Page 38

Comments to this Manuals

Related products and manuals for Acoustics Panasonic WJ-HD100