- 44 -
4 Touch [EXIT] to complete the setting.
≥ The focus positions of the items you have set will be registered.
≥ The focus position settings are cancelled in the following cases:
j If you turn the unit off
j If you press the THUMBNAIL button
j If you operate the zoom
≥ Select the [FOCUS TRANSITION] menu.
(l 43)
≥ Register [FOCUS TRANS] to a USER button. (l 61)
1 Switch to Manual Focus Mode. (l 34)
2 Press the USER button to which [FOCUS TRANSITION] is registered or touch
the applicable USER button icon.
3 Touch a registered item ([1]s[3]).
≥ Focus Transition will start. Focus will shift slowly from the
current position to the registered position. This will take a
few seconds. (l 45)
≥ As the focus shifts, the Focus Transition bar will move
from [S] to [E].
≥ If you touch [INIT], focus will shift to the initial focus
position registered in Step 1 of “Registering a focus
position” (l 43).
4 Touch [EXIT] to exit Focus Transition.
≥ Focus Transition is not available in the following cases:
j During Freeze Frame (l 67)
j In Intelligent Auto Mode
j When the FOCUS A/M/¶ switch is set to [A]
j When colour bars are displayed.
j When a remote control (commercially-available) is connected (l 6)
≥ Focus Transition settings are cancelled in the following cases. To use Focus Transition again,
register a focus position again. (l 43)
j If you operate the zoom
j If you enable/disable [INFRARED REC] (l 146)
≥ You can switch between the items or exit Focus Transition by pressing the USER buttons 1s5.
Using Focus Transition
USER button Corresponding setting
USER1 to USER3 [1] to [3]
USER4 [INIT]
USER5 [EXIT]
Comments to this Manuals