Panasonic WVCS600_SERIES User Manual download pdf (Page 30)

- 27 -

11. Auto Focus Setting (AF MODE)

1. Move the cursor to AF MODE, and move the joystick to the left or

right to set auto focus operation mode.

MANUAL: The AF mode is activated by pressing the AF button of the

controller.

AUTO: AF mode is activated automatically after a manual panning,

tilting or zooming operation.

Note: AUTO in AF MODE is disabled unless SENS UP is set to OFF.

If SENS UP is not OFF, AF MODE is set automatically to

MANUAL.

2. To set an area

Move the cursor to MANUAL or AUTO, and press the CAM (SET) key.

The AF AREA SET menu is shown. Move the cursor to AREA, and

move the joystick to the left or right to select LARGE, MID or SMALL

for the area.

3. To confirm operation

To check auto focus operation, move the cursor to AF CHECK, and

press the CAM (SET) key.

Notes:

• When the electronic sensitivity enhancement (SENS UP) is active, this

function is automatically set to MANUAL.

• The auto focus lens may not function properly in AUTO under the

following conditions.

1. Dirt or water on window glass.

The auto focus may focus on the dirt or water.

2. Low lighting/illumination or zone marker is blinking.

3. Bright objects or high intensity objects.

4. Single colour with unfigured object such as white wall or fine felt.

5. No centre objects, sloping objects.

6. Far and near objects on the screen.

Important Notice:

• The object of motion detection should meet the following conditions.

1) It should be larger than 1/48 of the size of the picture screen.

2) The contrast ratio (at max. detection level) between the object

and the background picture on the screen should be more than

5%.

3) The time it takes the object to move from one end of the screen to

the other should be more than 0.1 seconds.

• Also under the following conditions, mask or adjust the detection level

to prevent malfunction.

1) When leaves or curtains etc, are swayed by the wind.

2) When a noisy picture exists such as under low light condition.

3) When the object is subjected to illumination by lighting

equipment that constantly turns on and off.

• The alarm signal will take about 0.2 second to reach the alarm

terminal of the VTR, after the camera detects the object.

Because the alarm signal is multiplexed on the video signal it may be

mistakenly interpreted by other video equipment as a time code

signal. Therefore, when this camera is not used in a Panasonic

Intelligent CCVE System, select OFF to prevent the above from

occurring.

** SET UP **

CAMERA ID OFF *

ALC/MANUAL ALC *

SHUTTER OFF

AGC ON

SENS UP OFF

SYNC INT

WHITE BAL ATW *

WIDE D-RANGE OFF

MOTION DET OFF

AF MODE MANUAL *

RET SPECIAL *

Camera setting menu

** AF AREA SET **

AREA MID

AF CHECK

→

PUSH SW

RET

** AF AREA SET **

AREA MID

AF CHECK

→

PUSH SW

RET

Area setting menu

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Comments to this Manuals

No comments

Panasonic WVCS600_SERIES User Manual Page 30

Comments to this Manuals

Related products and manuals for Camera accessories Panasonic WVCS600_SERIES