Panasonic SC-RT50 User Manual download pdf (Page 42)

RQT8655

Messages

On the television Page

On the unit’s display

The following messages or service numbers appear on the unit’s display when something unusual is detected during startup and use.

Cannot finish recording

completely.

pThe program was copy-protected.

pThe disc may be full.

pThe maximum number of times you can record the program is exceeded.

—

Cannot play. pYou inserted an incompatible disc (Discs recorded in PAL video, etc.). 7

Cannot record on the disc. pThe disc may be dirty or scratched. 8

Unable to format.

Please check the disc.

Cannot play back on this unit. p You tried to play a non-compatible image.

pTurn the unit off and re-insert the card.

Cannot record. Disc is full. pCreate space by deleting any unnecessary titles. [RAM] [-RW‹V›] [+RW]

[Even if you delete recorded content from DVD-R, DVD-R DL, +R or +R DL, there is no

increase in disc space. Available disc space on DVD-RW (DVD-Video format) or +RW

increases only when the last recorded title is deleted.]

pUse a new disc.

23, 31

—

Cannot record. Maximum

numbers of titles exceeded.

No disc. pThe disc may be upside down. —

No folders. pThere is no compatible folder in this unit. 7

No SD Card

No valid SD card.

pThe card is not inserted. If this message is displayed with a compatible card already

inserted, turn off the unit, remove and then re-insert the card.

pThe card inserted is not compatible or the card format does not match.

There is not enough free

space on the copying

destination.

pCreate space by deleting any unnecessary items. 23, 27, 31,

Please change the disc. pThere may be a problem with the disc. Press [ OPEN/CLOSE] on the main unit to

remove it and check it for scratches or dirt. (The unit turns off automatically after you open

the tray.)

This is a non-recordable disc. pThe unit cannot record on the disc you inserted. Insert a DVD-RAM or unfinalized DVD-R,

DVD-R DL, DVD-RW (DVD-Video format), +R, +R DL or +RW.

pYou inserted an unformatted DVD-RAM, DVD-RW, +R, +R DL or +RW. Format the disc

with this unit.

This disc is not formatted

properly.



pThe operation is prohibited by the unit or disc. —

SET 

(“t” stands for a number.)

pThe remote control and main unit are using different codes.

Change the code on the remote control.

Press and hold [ENTER] and the indicated number button at the

same time for more than 2 seconds.

(Setup Guide)

HARD ERR

(“HARD” and “ERR” are

alternately displayed.)

pIf there is no change after turning the unit on and off, consult the dealer where the unit was

purchased.

—

NoREAD pThe disc is dirty or badly scratched. The unit cannot record, play, or edit.

pThe message may appear when the DVD lens cleaner has finished cleaning.

Press [ OPEN/CLOSE] on the main unit to eject the disc.

—

NoWRIT pRecording may be unavailable due to a disc problem. Use a new disc. —

NoERAS pDeleting an item may be unavailable due to a disc problem. Use a new disc. —

PLEASE WAIT

(“PLEASE” and “WAIT” are

alternately displayed.)

pDisplayed when the unit is started. This is not malfunction.

pThe unit is carrying out its recovery process. You cannot operate the unit while “PLEASE

WAIT” is displayed.

—

UNSUPPORT

(“UNSUP” and “PORT” are

alternately displayed.)

pYou have inserted a disc the unit cannot play or record on. 6, 7

UNFORMAT

(“UNFOR” and “MAT” are

alternately displayed.)

pYou have inserted a new DVD-RW/+R/+R DL/+RW or a DVD-RAM/DVD-RW (DVD-Video

format) recorded on other equipment.

F74 pThe HDMI connection could not be authenticated due to a transfer malfunction. —

F75 pThe HDMI connection could not be authenticated due to an internal data malfunction. —

U59 pThe unit is hot.

The unit switches to standby for safety reasons. Wait about 30 minutes until the message

disappears.

Select a position with good ventilation when installing the unit. Do not block ventilation

holes on the top or rear of the unit.

—

U61 p(When a disc is not inserted) Displays when a malfunction has occurred during recording,

playback or copy. This is displayed when the unit is in the recovery process to return to

normal operation; it is not broken. Once the display clears you can use the unit again.

—

U71 pThe connected equipment is not HDMI compatible. —

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Comments to this Manuals

No comments

Panasonic SC-RT50 User Manual Page 42

Comments to this Manuals

Related products and manuals for Acoustics Panasonic SC-RT50