Panasonic WJ-HD100 User Manual download pdf (Page 28)

1. Move the cursor to VMD SETUP with the up [▲] or

down [▼] button.

2. Rotate the JogDial to select the desired parameter, then

press the JogDial. The default is OFF.

[LOW ]: Low sensitivity motion detection is enabled.

[MID ]: Medium sensitivity motion detection is

enabled.

[HIGH ]: High sensitivity motion detection is enabled.

[OFF]: Motion detection is disabled.

The area setup window appears with an asterisk when

other than OFF is selected. The asterisk represents the

upper-left or bottom-right of the detection area. The

division lines are not actually displayed on the monitor.

2. Rotate the JogDial to select ON or OFF.

ON: Buzzer beeps while alarm is active.

OFF: Buzzer does not beep.

● Motion Detector Setup

306 VMD SETUP

A VMD or Video Motion Detector senses changes in the

video signals within a preset area and supplies alarm out-

put. When a change is detected, the recorder starts

recording. The detection sensitivity and area are selected

on this menu.

Notes:

• VMD should be used with an ordinary camera input to

the unit. Select [OFF] to avoid useless VMD when a

video multiplexer or combination camera supplies the

input to the unit.

• Make sure that the date and status displays are not

located within the motion detection area on the monitor.

Otherwise the motion detector could be misled.

• Set the ALARM SUSPEND to ON with the LCD button

when VMD is unnecessarily activated during the VMD

setup.

• VMD does not function while playing back.

3. Set the upper-left end of the detection area. Move the

asterisk to the right or left with the JogDial, and up or

down by pressing the up [▲] or down [▼] button.

4. Press the JogDial to enter the upper-left end of the

detection area. The asterisk position is highlighted.

5. Set the bottom-right end of the detection area similar to

steps 3 and 4 above.

6. Press the JogDial. The area is highlighted.

Up to 4 areas can be selected. These may partially

overlap. Repeat steps 3 to 6 to select more areas. To

unselect an area, move the cursor to the upper-left end

of the area, and then press the JogDial.

PUSH • PAUSE

SET

REW/FF

STEP

ALARM SETUP

REC MODE SF- 12H

REC RATE 15FPS

REC QUALITY 10(1-10)

DURATION 10S

ALARM BUZZER ON

VMD SETUP OFF

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Comments to this Manuals

No comments

Panasonic WJ-HD100 User Manual Page 28

Comments to this Manuals

Related products and manuals for Acoustics Panasonic WJ-HD100