Panasonic NVGS90 Operations Instructions download pdf (Page 43)

Others

LSQT1290

5: The movie camera cannot be operated

though powered up.

The movie camera does not operate

normally.

• The movie camera cannot be operated unless

you open the LCD monitor or extend the

viewfinder.

• Remove the cassette and then press the

[RESET] button. (

-44-) If normal conditions are

not restored yet, turn off the power. Then,

about 1 minute later, turn on the power again.

6: The cassette cannot be removed.

• Does the status indicator comes on when

opening the cassette cover? (

-13-) Make sure

that the battery and the AC adaptor are

properly connected. (

-8-)

• Is the battery in use discharged? Charge the

battery and remove the cassette.

• Close the cassette cover completely, and fully

open it again. (

-13-)

7: No operation other than cassette removal

can be performed.

• Has condensation occurred? Wait until the

condensation indication disappears. (

-45-)

Recording

1: Recording does not start although power is

supplied to the movie camera and the

cassette is correctly inserted.

• Is the accidental erasure prevention slider on

the cassette open? If it is open (set to [SAVE]),

recording cannot be performed. (

-14-)

• Is the tape wound to the end? Insert a new

cassette.

• Is the recording mode set? When in the

playback mode, recording cannot be

performed. (

-9-)

• Has condensation occurred? No operation

other than cassette removal can be performed

when condensation occurs. Wait until the

condensation indication disappears. (

-45-)

• Is the cassette cover open? If the cover is

open, the movie camera may not operate

normally. Close the cassette cover. (

-13-)

2: The screen has changed suddenly.

• Has the demonstration started? In the Tape

Recording mode, if you set [DEMO MODE] >>

[ON] without inserting a cassette, the

demonstration starts. For normal use, set this

function to [OFF]. (

-39-)

3: A cassette cannot be inserted.

• Has condensation occurred? Wait until the

condensation indication disappears.

4: Auto focus function does not work.

• Is manual focus mode selected? If auto focus

mode is selected, focus is automatically

adjusted.

• There are some recording subjects and

surroundings for which the auto focus does not

operate correctly. (

-49-) If so, use the manual

focus mode to adjust the focus. (

-29-)

Indications

1: A sentence is displayed in red in the screen

centre.

• Read the contents and respond to them. (

-41-)

2: The remaining tape time indication

disappears.

• The remaining tape time indication may

disappear temporarily during frame-by-frame

playback or other operation. If you continue

ordinary recording or playback, the indication is

restored.

3: The remaining tape time Indication does not

match the actual remaining tape time.

• If scenes of less than 15 seconds are

continuously recorded, the remaining tape time

cannot be correctly displayed.

• In some cases, the remaining tape time

indication may show remaining tape time that is

2 to 3 minutes shorter than the actual

remaining tape time.

4: A function indication such as mode

indication, remaining tape time indication,

or time code indication is not shown.

• If you set [SETUP] >> [DISPLAY] >> [OFF],

indications other than the tape running

condition, warning, and date indications

disappear.

5: “CHECK THE LENS COVER.” is displayed.

• Open the lens cover before turning the unit on.

• This message may appear if you try to record in

extremely dark places.

LSQT1290_ENG.book 43 ページ２００８年３月４日　火曜日　午後２時２０分

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 199 200

Comments to this Manuals

No comments

Panasonic NVGS90 Operations Instructions Page 43

Comments to this Manuals

Related products and manuals for Camcorders Panasonic NVGS90