Panasonic PVGS500 Operations Instructions download pdf (Page 29)

Before using

LSQT0975

ª Selecting the remote control mode

If 2 Camcorders are used simultaneously, set the

mode for one pair of Camcorder and remote

control to [VCR1] and that of the other pair to

[VCR2]. This will prevent interference between

the 2 pairs. (The default setting is [VCR1]. When

the button-type battery is replaced, the setting will

revert to the default [VCR1].)

1 Setting on the Camcorder:

Set [SETUP] >> [REMOTE] >> [VCR1] or

[VCR2].

2 Setting on the remote control:

[VCR1]:

Press [D] and [∫] simultaneously. 1

[VCR2]:

Press [E] and [∫] simultaneously. 2

Concerning the button-type battery

≥When the button-type battery runs down,

replace it with a new battery (part number:

CR2025). The battery is normally expected to

last about 1 year, but it depends on operation

frequency.

≥Keep the button-type battery out of the reach of

children.

≥If the remote control mode of the Camcorder

and that of the remote control do not match with

each other, “REMOTE” will appear. When the

remote control is operated for the first time after

the Camcorder is turned on, “CHECK REMOTE

MODE” (

-73-) will appear and operation is

impossible. Set the same remote control mode.

≥The remote control is intended for indoor

operation. Outdoors or under strong light, the

Camcorder may not operate properly even

within the usable ranges.

Magic Wire Remote Control

This controller can be used from different high

and low angles. It is also handy when a tripod is

used. When you do not use the controller, attach

the clip to the grip belt. Left-handed users can use

this Camcorder more easily.

(1) Recording start/stop button [REC]

(2) Zoom lever [W/T]

(3) Photoshot button [PHOTO SHOT]

Connect the Magic Wire Remote

Control to the Camcorder

1 Plug the Magic Wire Remote Control into

the [REMOTE/MIC] terminal as far as it

goes.

About the clip (on the backside)

When you move with the clip attached to your

pocket or elsewhere, beware of knocking over the

tripod and causing the Camcorder to fall off the

table.

≥The [PHOTO SHOT] button on the Magic Wire

Remote Control cannot be pressed halfway.

≥If the pin plug of the control is not inserted

securely into the [REMOTE/MIC] terminal as far

as it will go, normal operation may not be

ensured.

≥Before using, make sure that the plug is

inserted securely into the terminal as far as it

will go.

2 1

(1)

(2)

(3)

REMOTE/MIC

LSQT0975_ENG.book 29 ページ２００５年１２月１９日　月曜日　午前９時５１分

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 95 96

Comments to this Manuals

No comments

Panasonic PVGS500 Operations Instructions Page 29

Comments to this Manuals

Related products and manuals for Camcorders Panasonic PVGS500