Panasonic WJ-GXE100 Installation Guide download pdf (Page 24)

Configure the network settings

Configuring the unit so that it can be accessed from a PC

The following are descriptions for when the unit with default settings is configured. If you are

using firewall software on your PC, the Setup Program may not be able to find any units on

your network. Configure the setting of the unit after temporarily invalidating the firewall

software. Contact the network administrator or your Internet service provider for information

about configuring the settings of the network.

Insert the provided CD-ROM into the CD-ROM drive of your PC.

 • TheLicenseAgreementwillbedisplayed.ReadtheAgreementandchoose“Iacceptthe

term in the license agreement”, and click [OK].

 • Thelauncherwindowwillbedisplayed.Ifthelauncherwindowisnotdisplayed,double

click the “CDLauncher.exe” file on the CD-ROM.

Note:

•Refer to “Using the CD-ROM” in the Operating Instructions on the provided CD-ROM for

further information about CDLauncher.

x Click the [Run] button next to [IP Setting Software].

“Panasonic IP Setting Software” page will be displayed. Click the [Network Settings] button

after selecting the MAC address/IP address of the unit to be configured.

c Select the unit you want to configure, and click [Access Camera].

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Panasonic WJ-GXE100 Installation Guide Page 24