Panasonic PT-DS8500U Operations Instructions download pdf (Page 13)

Precautions with regard to safety

ENGLISH -

Important

Information

Cautions when setting the projectors 1



When installing and using the projector with a method other than oor standing installing using adjustable

feet, x it with the 5 ceiling mounting screws (shown in the gure).

(Screw diameter: M6, Tapping depth inside set: 8 mm)

Make a clearance of at least 5 mm between the projector bottom and setting surface by inserting spacers

(metallic) etc. between them.

The adjustable feet can be removed if they are not necessary for installation. However, do not use the screw

holes for them to x the projector.

Do not tighten other screws etc. into the screw holes for the adjustable feet.

Doing so can break the set.

When installing the removed adjustable feet again, note that the front and rear ones have different lengths.

(The longer screws are used for front feet. Length of front leg screw: 65 mm, Length of rear leg screw:

23 mm)

When installing the projector with a method other than oor standing installing, do not adjust its angle with the

adjustable feet. Doing so can break the set.

Ceiling mounting screws (M6)

Gap (Min. 5 mm)

Make sure air can circulate

around the air intake vent.

Failure to do so may result

in the projector not operating

properly.

Spacers

Base

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 128 129

No comments

Panasonic PT-DS8500U Operations Instructions Page 13