Panasonic PT-DS8500U Operations Instructions download pdf (Page 45)

Projecting

ENGLISH -

Basic Operation

If the lens is heavy or the projector is installed so that it is tilted, the lens may be tilted, resulting in the focus

becoming unbalanced.

In such a case, refer to the gure 3 and table below, and follow the procedure below to perform adjustment.

Adjustment procedure

Display the internal test pattern grid, and defocus the image.

Adjust the lens focus till one or more sides of the grid comes into focus. Note the appropriate screws

for the out-of-focus sides of the grid as described below.

Loosen the locking screws for each of the adjustment screws , and as needed, following the

indications in the example. The screws to be adjusted correspond to the out-of-focus sides of the

image.

Attention

Make adjustments in up to two places, and fully turn the screw clockwise in at least one place.

Turn the adjustment screws (corresponding to the locking screws loosened in step 3)

counterclockwise slightly till the out-of-focus image sides are in focus. (Turning the screws

counterclockwise moves the lens bracket and tilts the lens toward the screen.)

Readjust the lens shift position with the remote if needed.

Refocus the image as in steps 1 and 2 above. Fine adjust the focus evenness as needed, as described

in step 4.

When adjustment is complete, tighten the locking screws.

Adjust the Focus.

Tool to be used : Allen hex socket driver or Allen wrench (2.5 mm diagonal hexagon)

An Allen wrench is supplied with the ET-D75LE6 and ET-D75LE8 optional lens.

Figure 3 : Relation between the adjustment place and adjustment screw

When optimal focus point

is at the back of screen

for V up

When optimal focus point

is at the back of screen

for V bottom

When optimal focus point

is at the back of screen

for H left

When optimal focus point

is at the back of screen

for H right

Turn counterclockwise ——— ——— ———

——— Turn counterclockwise Turn counterclockwise ———

——— Turn counterclockwise ——— Turn counterclockwise

Adjustment place :

The place where the just-in-focus

point is at the back.

Projector

Screen

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 128 129

Comments to this Manuals

No comments

Panasonic PT-DS8500U Operations Instructions Page 45

Comments to this Manuals

Related products and manuals for Data projectors Panasonic PT-DS8500U