Panasonic WV-SW458 Installation Guide download pdf (Page 20)

Using the mount bracket (accessory)

SW458

Note:

 • Whenthecameraismountedontheceilingorwallwithaholeforcablerunning,orthecamera

is mounted using open wiring, the mount bracket (accessory) is used.

IMPORTANT:

 • If open wiring is conducted, be sure to use conduits

and run the cables inside the tubes to protect the

cables from direct sunlight.

 • Installationworkshallbesuchthatthereisnoexposure

to water into the architecture through the conduits hav-

ing been joined.

z Loosen two fixing screws on both ends of the base cover (accessory) by using the bit for tam-

perproof screw (accessory), and remove the base cover (accessory).

When using a conduit, use a hexagon wrench (ISO 2936, width across flats S=5 mm

{5/64 inches}) or other tool and also remove the cap for the female thread for the conduit.

Note:

•The female thread for the conduit is compliant with ANSI NPSM (parallel pipe threads)

3/4 inch or G3/4 of ISO 228-1.

Mount bracket (accessory)

Base cover (accessory)

Cap for the female thread for the conduit

Base cover xing screws

Conduit

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Panasonic WV-SW458 Installation Guide Page 20