Panasonic MINAS A4P Series User Manual download pdf (Page 96)

How to Use the Console

• When you change the parameters which contents become valid after resetting, will be 

displayed after finishing wiring. Turn off the control power once to reset.



Note 1)When writing error occurs, make writing again. If the writing error repeats many times, 

 this might be a failure.

Note 2)Don't turn off the power during EEPROM writing. Incorrect data might be written. 

 If this happens, set up all of parameters again, and re-write after checking the data.

Note 3)Between and , take care not to pull out a console connector from a servo



 driver main unit. If the connector is pulled out accidentally, insert the connector again and retry

 from the beginning.



<Notice>

When you have set the parameters, write the parameters into EEPROM. If you turn the power supply

off before writing the parameters into EEPROM, those parameters are cleared.

Starts writing.

Finishes writing

Writing completes Writing error

Starting from the initial LED status, 

press three time after pressing ,

then brings the display of 

EEPROM Writing Mode,

Keep pressing

until the display changes to when you execute writing.

“ ” increases while 

keep pressing 

(for approx. 5sec) as 

the right fig. shows.

Press to make 

EXECUTION DISPLAY to



To move to the next process, press .

EEPROM Write Mode

EEPROM Writing

Operation at SELECTION display

Operation at EXECUTION display

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 231 232

No comments

Panasonic MINAS A4P Series User Manual Page 96