Panasonic MDDDT5540 User Manual download pdf (Page 45)

- 45 -

Preparations and Adjustments

Operation with CN I/F Connected

1) Connect CN I/F.

2) Connect the control signal (COM+/-) to the power supply (12 to 24V DC).

3) Turn the main power (amplifier) ON.

4) Check the defaults of the parameters. Control mode setting (Pr2 value: 0).

5) Connect between SRV-ON (CN I/F pin 2) and COM- (CN I/F pin 13) to make Servo-On active. The

motor will be kept excited.

Run at Position Control Mode

1) Set Pr42 (Command Pulse Input Mode Set-Up) according to the output form of the controller. Then

write it down to EEPROM. Then turn the power OFF and then ON again.

2) Send a low-frequency pulse signal from the controller to the amplifier to run the motor at low

speed.

3) Check the motor speed at monitor mode with PANATERM

“

• Make sure that the speed is per the set-up.

• Check if the motor stops when the command (pulse) is stopped.

Use the controller to send command pulses.

COM+

SRV-ON

PULS1

PULS2

SIGN1

SIGN2

GND

COM–

120Ω

In case of op

collector for

CW/CCW

pulse inputs

Z-phase

output

for homing

12V~24V

No.

Input signal

Servo-ON

Counter clear

Monitor display

+ A

---

PrNo.

Pr02

Pr04

Pr42

Parameter description

Control mode set-up

Overtravel input inhibit

Command pulse input mode set-up

Value

Wiring Diagram

Parameters

Input Signals Status

with PANATERM

“

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 132 133

Comments to this Manuals

Riaz uddin 01 Jun 2024 | 12:31:56

Ac sarvo motor

Michael kisilu 30 Mar 2025 | 07:23:22

Parameters set

MD CHAN MIA 07 May 2025 | 19:27:14

Pdf

Panasonic MDDDT5540 User Manual Page 45

Comments to this Manuals

Related products and manuals for Tools Panasonic MDDDT5540